Fusion 360 Task 2
Creating Space using Initials
I used my initials E H T to create this space, I encountered some challenges during this task with the part of creating a 'shell' as the exterior parts were too thin. I played around with it and found a solution to edit the original sketches to make the lettres thicker so it would shell properly.
Final piece:
1st Attempt:
Creating Space using Initials
I used my initials E H T to create this space, I encountered some challenges during this task with the part of creating a 'shell' as the exterior parts were too thin. I played around with it and found a solution to edit the original sketches to make the lettres thicker so it would shell properly.
Final piece:
1st Attempt:
Comments
Post a Comment